- ページ 4

水ポンプ Armstrong 4030のPDF 据付・取扱説明書をオンラインで閲覧またはダウンロードできます。Armstrong 4030 12 ページ。 Base mounted pump
Armstrong 4030 にも：据付・取扱説明書 (12 ページ)

ページを印刷する

i nstal la ti on &

o p era t i n g i n stru ction s

ce conformities

For declaration of Conformities, contact Armstrong.

introduction

This document contains specific information regarding

the safe installation, operating and maintenance of the

Series 4030 pumps and should be read and understood

by installing, operating and maintenance personnel. The

equipment supplied has been designed and constructed to

be safe and without risk to health and safety when properly

installed, operated and maintained. The instructions

following must be strictly adhered to. If clarification is

needed on any point please contact Armstrong quoting the

equipment serial number.

warning symbols

Safety instruction where an electrical hazard is

involved.

Safety instruction where non-compliance would

affect safety risk.

Safety instruction relating to safe operation of the

equipment. (at tention)

instructions for safe use

No installation of this equipment should take place unless

this document has been studied and understood. Handling,

transportation and installation of this equipment should only

undertaken by trained personnel with proper use of lifting

equipment. See later diagrams for lifting advice. Refer to the

pump nameplate for pump speed, pressure and temperature

limitations. The limits stated must not be exceeded without

written permission from Armstrong.

temper ature

Where under normal operating conditions the limit of

68°c / 155°f (Restricted Zone) for normal touch, or

8 0°c / 176°f (Unrestricted Zone) for unintentional touch,

may be experienced, steps should be taken to minimize

contact or warn operators/users that normal operating

conditions will be exceeded. In certain cases where the

temperature of the pumped liquid exceeds the above

stated temperature levels, pump casing temperatures may

exceed 10 0°c /2 12°f and not withstanding pump insulation

techniques appropriate measures must be taken to minimize

risk for operating personnel.

Series 4030

Base mounted pump

noise levels

For Pumping Unit Sound Pressure Levels, see Motor

Technical Data sheet (file no. 48 .11l).

stor age

Pumps not immediately placed into service, or removed from

service and stored, must be properly prepared to prevent

excessive rusting. Pump port protection plates must not be

removed until the pump is ready to connect to the piping.

Rotate the shaft periodically (At least monthly) to keep

rotating element free and bearings fully functional. For long-

term storage, the pump must be placed in a vertical position

in a dry environment. Internal rusting can be prevented by

removing the plugs at the top and bottom of the casing and

drain or air blow out all water to prevent rust buildup or the

possibility of freezing. Be sure to reinstall the plugs when the

unit is made operational. Rust proofing or packing the casing

with moisture absorbing material and covering the flanges is

acceptable. When returning to service be sure to remove the

drying agent from the pump.

uncr ating

Armstrong End Suction pumps are thoroughly inspected

before shipment to assure they meet with your order

requirements. After removing the pump from the crate, make

sure the equipment is in good order and that all components

are received as called for on the packing list. Any shortages

or damage should be reported immediately. Use extreme

care in handling the unit, placing slings and hooks carefully

so that stress will not be imposed on the pump. Never place

cable slings around the pump shaft. The eye bolts or lifting

lugs on the motor are intended for lifting only the motor and

not the complete unit.

handling

Use slings as shown in the diagram to lift the set. Do not use

the motor eyebolts to lift the pump set. See the delivery note

for the weight of the set.