Dirty hand 101172 Manual de instrucciones - Página 15
Navegue en línea o descargue pdf Manual de instrucciones para Generador portátil Dirty hand 101172. Dirty hand 101172 20 páginas. 800 rated watts/900 maximum watts portable power generator
Imprimir páginaDisconnect the spark plug wire, keeping it away from the spark plug.
PROBLEM
The engine will not start.
• Improper gasoline/2 cycle oil mix.
• No fuel in tank or fuel valve closed.
• Choke not in start position.
• Low quality or deteriorated, old gasoline.
• Dirty fuel passageways blocking fuel flow.
• Carburetor needle stuck. Smell of fuel in air.
• Too much fuel in chamber.
• Spark plug wire not connected securely.
• Spark plug electrode wet or dirty.
• Incorrect spark plug gap.
• Spark plug wire or spark plug broken.
• Cylinder not lubricated after long storage.
Engine misfires, backfires or knocks.
• Spark plug wire loose.
• Incorrect spark plug gap.
• Spark plug wire or spark plug broken.
• Low quality or deteriorated, old gasoline.
• Engine too cold.
• Engine knocks.
Engine stops suddenly.
• Low quality or deteriorated, old gasoline.
• Defective fuel cap creates vacuum.
• Improper idle speed.
• Incorrect timing, deposit buildup, worn
engine or other mechanical problem.
Engine Troubleshooting
BEFORE PERFORMING ANY MAINTENANCE
PROCEDURE STOP THE ENGINE, WAIT FIVE (5)
MINUTES TO ALLOW ALL PARTS TO COOL.
!
WARNING
SOLUTION
• Drain fuel. Remix and add new fuel using 50:1 gas/oil ratio.
• Add fuel and open fuel valve.
• Place choke in START position and pull recoil starter.
• Drain fuel. Add new fresh 89+ octane/2-cycle oil mix.
• Clean out fuel passageways using fuel additive.
• Gently tap side of carburetor with screwdriver handle.
• Turn choke to RUN position.
• Connect spark plug wire securely to spark plug.
• Remove and clean spark plug. Reinstall spark plug and restart.
• Reset spark plug gap according to specifications.
• Replace spark plug and/or spark plug wire.
• Remove spark plug. Pour tablespoon of oil into spark plug hole.
Replace spark plug. Crank engine a few times and try to start.
• If the engine still will not start, visit our web site at www.
dirtyhandtools.com or call 1-877-487-8275 for assistance.
• Tighten spark plug wire.
• Reset spark plug gap according to specifications.
• Replace spark plug and/or spark plug wire.
• Drain fuel. Add new fresh 89+ octane/2-cycle oil mix.
• Use cold weather fuel and oil additives.
• Engine overloaded, do not exceed recommended load rating.
• Drain fuel. Add new fresh 89+ octane/2-cycle oil mix.
• Test and replace fuel cap.
• Move choke to RUN position.
• Requires qualified technician.
15