Disaster Area Designs DPC.micro Manual del usuario - Página 2

Navegue en línea o descargue pdf Manual del usuario para Interruptor Disaster Area Designs DPC.micro. Disaster Area Designs DPC.micro 4 páginas. Compact programmable effects switcher

Imprimir página

ntrOductIOn

Thank you for your interest in the DPC.micro Programmable Effects Switcher.

The DPC.micro packs three true-bypass effects loops into a small footprint, adding in MIDI

control and preset capability for good measure. Each loop may be individually controlled

using the footswitches on the DPC.micro or by MIDI remote control. You can also save your

favorite effects loop settings to preset combinations for later recall.

ns and

Most of the connections to the DPC.micro are located on the rear panel of the device as

shown below.

The white jacks on the rear panel serve as input and output connections. Plug your instru-

ment into the white jack nearest to the power jack, and plug your amplifier into the white jack

next to the USB port.

The remaining jacks connect to your pedals. The black jacks are the effects sends, which

should connect to the input of each pedal. The red jacks are the returns, and connect to the

output of each pedal.

Connect your pedals as shown in the diagram above. Make sure to engage all of your pedals

in the loops! The DPC.micro can bypass and engage them remotely only if the pedals are

powered on and engaged.

The bypass state of each loop will be shown on the DPC.micro, but the LEDs on the looped

pedals themselves will not change.

uts