Disaster Area Designs DPC.micro 사용자 설명서 - 페이지 2
{카테고리_이름} Disaster Area Designs DPC.micro에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Disaster Area Designs DPC.micro 4 페이지. Compact programmable effects switcher
페이지 인쇄I
ntrOductIOn
Thank you for your interest in the DPC.micro Programmable Effects Switcher.
The DPC.micro packs three true-bypass effects loops into a small footprint, adding in MIDI
control and preset capability for good measure. Each loop may be individually controlled
using the footswitches on the DPC.micro or by MIDI remote control. You can also save your
favorite effects loop settings to preset combinations for later recall.
I
O
ns and
Most of the connections to the DPC.micro are located on the rear panel of the device as
shown below.
The white jacks on the rear panel serve as input and output connections. Plug your instru-
ment into the white jack nearest to the power jack, and plug your amplifier into the white jack
next to the USB port.
The remaining jacks connect to your pedals. The black jacks are the effects sends, which
should connect to the input of each pedal. The red jacks are the returns, and connect to the
output of each pedal.
Connect your pedals as shown in the diagram above. Make sure to engage all of your pedals
in the loops! The DPC.micro can bypass and engage them remotely only if the pedals are
powered on and engaged.
The bypass state of each loop will be shown on the DPC.micro, but the LEDs on the looped
pedals themselves will not change.
uts