Blade Vusion 250 V2 Manual de instrucciones - Página 6

Navegue en línea o descargue pdf Manual de instrucciones para Drones Blade Vusion 250 V2. Blade Vusion 250 V2 18 páginas. Fpv-ready racing drone rtf

Binding

The transmitter included with this aircraft is pre-bound to the

receiver at the factory. If it becomes necessary to re-bind the

transmitter to the receiver, indicated by a red receiver status

LED, follow the procedure given in the table.

If you encounter problems, obey the binding instructions and refer

to the troubleshooting guide for further instructions. If necessary,

contact the appropriate Horizon Hobby product support ofﬁ ce.

Flight Mode Switch

Aileron (Roll) (Left/Right)

Elevator (Pitch) (Up/Down)

Failsafe/Beacon

The quadcopter will autoland and start beeping if the signal

from the transmitter is lost. This feature can be used as a

beacon to help locate the quadcopter, if it has crashed, by

Elevator Trim Aileron Trim Rudder Trim Throttle Trim

Binding Procedure

1. Power off your transmitter.

2. Remove the upper rear cover of the aircraft. Press down on

the rear edge of the cover and pull the cover out of the frame.

3. Power on the aircraft.

4. Press and hold the bind button until the red LED on the

control board fl ashes rapidly.

5. Power on the transmitter. The LED on the control board

glows solid to show the bind was successful.

Monitor Cradle

Dual Rate Switch

LEDs

turning off the transmitter and listening for the beeping of

the aircraft.

LED

Bind Button

On/Off Switch

Rudder (Yaw) (Left/Right)

Throttle (Up/Down)