Blade Vusion 250 V2 Руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Дроны Blade Vusion 250 V2. Blade Vusion 250 V2 18 страниц. Fpv-ready racing drone rtf

Печатать страницу
EN

Binding

The transmitter included with this aircraft is pre-bound to the
receiver at the factory. If it becomes necessary to re-bind the
transmitter to the receiver, indicated by a red receiver status
LED, follow the procedure given in the table.
If you encounter problems, obey the binding instructions and refer
to the troubleshooting guide for further instructions. If necessary,
contact the appropriate Horizon Hobby product support offi ce.

Transmitter Controls

Flight Mode Switch
F
E
D
A
Aileron (Roll) (Left/Right)
Elevator (Pitch) (Up/Down)
Failsafe/Beacon
The quadcopter will autoland and start beeping if the signal
from the transmitter is lost. This feature can be used as a
beacon to help locate the quadcopter, if it has crashed, by
B
C
Elevator Trim Aileron Trim Rudder Trim Throttle Trim
Binding Procedure
1. Power off your transmitter.
2. Remove the upper rear cover of the aircraft. Press down on
the rear edge of the cover and pull the cover out of the frame.
3. Power on the aircraft.
4. Press and hold the bind button until the red LED on the
control board fl ashes rapidly.
5. Power on the transmitter. The LED on the control board
glows solid to show the bind was successful.
Monitor Cradle
Dual Rate Switch
LEDs
D
turning off the transmitter and listening for the beeping of
the aircraft.
6
LED
Bind Button
A
B
C
On/Off Switch
E
F
Rudder (Yaw) (Left/Right)
Throttle (Up/Down)