3D Creations North American P 51 D Mustang Manual de instrucciones de montaje - Página 14
Navegue en línea o descargue pdf Manual de instrucciones de montaje para Juguete 3D Creations North American P 51 D Mustang. 3D Creations North American P 51 D Mustang 15 páginas. Paper scale model kit
Imprimir página
Propeller and Spinner Assembly
Cut out parts # 47, 48 and 50 using the
black boarder that surrounds them.
Glue these parts flat to your cardboard.
After the glue is set cut out the pieces
to shape. Glue all the #48 pieces
together by stacking them one on top
of another. Make certain that they are
lined up to each other so the shape is
maintained. Glue part # 47 on top of
the stack of #48's. See figure 40. This
part is designed to be inserted in to the
nose section of the fuselage. Check to
see if this part fits in the opening.
Do
not glue it in place at this
time. If the
piece seems to be oversized you can
evenly file or sand the around the
outside edge until you get the correct
size. Don't
take off too
much at once
and make sure
you maintain
the correct
shape. This
part is to fit
snugly in
place. Glue
part # 49 to the
backside of
part # 50
making sure
that you have it
lined up as
accurately as possible. Trim off any excess to even up the edges. Glue the propeller hub
to part # 47 using the white ring to help get the proper location. See figure 40. Cut out
part # 27. The Gray area is there to make it easier to cut out the lighter colored sections of
the spinner. Imagine the spinner as a flower. The goal is to form a cup by overlapping the
pedals. Use the black lines as a guide. Overlap them so the black line is just covered.
Trim the areas indicated in figure 41 to allow for the propeller blades to stick out.
14