3D Hobby Shop SLICK 540 Manual de montaje - Página 14

Navegue en línea o descargue pdf Manual de montaje para Juguete 3D Hobby Shop SLICK 540. 3D Hobby Shop SLICK 540 19 páginas.

Mount the rudder servo as shown.

Install the rudder servo arm, and spend time to find the exact correct length of the pull-pull wires before

attaching the pull wire ends at the front. The system provides approximately .25 inch of adjustment on

each wire, so your assembly must be accurate. When you are certain your wire length is correct, crimp

the wire to the ends and use the adjustor to properly tension the wires as a final adjustment. We want the

wires to be snug, without sag, but not springy-tight. NOTE – Proper adjustment of the pull-pull wires is

critical. Too-loose wires allow the rudder to flop back and forth in flight, ruining precision flight. Too-tight

wires cause the servo to drag and lose power, leading to a lack of rudder authority.