3D Hobby Shop SLICK 540 Manual de montaje - Página 15

Navegue en línea o descargue pdf Manual de montaje para Juguete 3D Hobby Shop SLICK 540. 3D Hobby Shop SLICK 540 19 páginas.

Open the covering over the elevator servo hole and the elevator control horn slot, and install the elevator

servo and pushrod as shown. The elevator uses the longest pushrod in the kit. Glue the control horn into

the slot with medium or thick CA glue. Attach the pushrod to the horn with a 2mm screw, washer, and

nut. Be sure to use CA glue to lock the nut in place.

. Install servo and assemble the pushrod connector onto the servo arm as shown. Note that this pushrod

connector must swivel as the arm moves, so it cannot be tightened down all the way. Just make the nut

on the connector snug, then lock in place with CA glue.

Assemble the ailerons onto the wings, flex them up and down to check for free motion, and drip thin CA

glue onto each hinge. Allow to dry. Remove covering over the servo opening and aileron-horn slot as

shown. Note the shape of the aileron horns.