Cubic PULSE 160 Manual del usuario - Página 7
Navegue en línea o descargue pdf Manual del usuario para Acuarios Cubic PULSE 160. Cubic PULSE 160 17 páginas. Aquarium systems
También para Cubic PULSE 160: Manual del usuario (12 páginas)
Imprimir página
PULSE 160 USER GUIDE
Section 3: Setting up aquarium
IMPORTANT: These aquariums have been designed to run on a level surface. If the surface it is placed
on is not level the filter boxes will not run evenly leading to bubbles being sucked into the display. If this
issue should occur, please refer to section 6 for a solution.
01
Place the aquarium on a flat and level surface
02
Remove all components packed inside the aquarium
03
Remove any tape or plastic that has been used to protect or secure the tank whilst in transit
04
Connect the pumps, unions and pipes and check they are in place and secure as shown in figure 2
05
Connect the pump power lead and LED power lead into their corresponding connections on the
bottom of the filter chamber. Please be noted that the Pulse 160 requires 2 power supplies, one for
LEDs and another for pumps.
06
Rinse the bio media thoroughly, and place them into the filtration chambers
07
Add water to the aquarium until the water falls into the filtration chambers, fill it up to the Max
level marked on the filtration chambers
08
Plug the power supplies into the wall sockets
09
As pumps start to push the water to the aquarium, the water level in the filtration chambers will
drop. Please add some more water until water levels stay at the Max level in the filtration
chambers.
10
Adjust the water adjustment valves on both sides until water levels in both filtration chambers
stay the same. The water adjustment valves should be set at about 50% open (see section 6 for
more details)
11
The water level inside the aquarium can be set at 2 different levels by placing or removing water
level adjuster (see next section 3.1 for more details)
07