3D Systems ZPRINTER 250 Manual de inicio rápido - Página 9
Navegue en línea o descargue pdf Manual de inicio rápido para Impresoras 3D 3D Systems ZPRINTER 250. 3D Systems ZPRINTER 250 16 páginas.
Imprimir página
1.
Open the printer top cover and the Service Station cover.
2.
Place paper towels around the Service Station. Also cover
the front overflow and the Build Bed with paper towels.
3dscentral.3dsystems.com
3.
Pull the Service Station wiper lever all the way forward until
the rubber squeegees are fully exposed. Hold the lever in
this position while you clean the squeegees.
Wiper
Lever
Wiper
Lever
Squeegees
4.
Squirt water on and around the squeegees.
Important: Don't get water in the front overflow or on the
build bed.
5.
Wipe the front and back of the squeegees clean. Use the
Pick to scrape away any excess powder.
6.
Thoroughly clean and dry the
•
•
•
•
7.
Push the wiper lever back to its original position.
Squeegees
Service Station
Deck
Build Bed
Front Overflow.
9