3Doodler Create+ Manual del usuario - Página 8
Navegue en línea o descargue pdf Manual del usuario para Accesorios 3Doodler Create+. 3Doodler Create+ 11 páginas.
También para 3Doodler Create+: Manual del usuario (16 páginas)
Imprimir página
7.
My Pen won't heat
up (LED light stays
red)
SECTION 4: TIPS AND BEST PRACTICES
Pay attention
to filament types
and settings
Switching
between filament
types
Do not forget
to snip your
Plastic ends
02/2022
It takes around 60-90 seconds for your pen to heat up. If, after that time,
the pen still does not heat up and the LED light remains RED, turn the
Pen OFF and back ON and try again. If that still does not work, please
contact us at
•
For optimal Doodling, we suggest using the correct temperature settings
for your plastic.
•
Double check which type of plastic you are using before you set your
pen to the correct temperature setting (
strands get mixed up, here is a handy table for sorting and identifying
what you're working with.
•
For more detailed information on filament types, visit our FAQ:
learn.the3Doodler.com/faqs/.
PLA:
Temp: PLA Temp
LED Light:
GREEN
Feature: Glossy plastic sticks to
fabric, windows, metal and other
hard surfaces.
How to tell: Very rigid, no white
semi-circle ends.
•
If you go from
PLA
to ABS, after clearing as much of the
adjust the filament setting on the pen to ABS/FLX, and then load in your
ABS
strand and start extruding.
•
If you're going from
ABS
to PLA, after clearing as much of the
can, insert a strand of
PLA
FLX
setting. As soon as you see your new material extruding out, set the
temperature to the proper
•
After removing a strand of plastic from the 3Doodler Create+,
cut and discard any partially melted material at the end of
the strand. This will reduce blockages or clogging issues.
and we will assist further.
. If your plastic
PLA
or ABS/FLX)
WOOD:
Temp: PLA Temp
LED Light:
GREEN
Feature: Great for embelishing
wood projects, this plant-based
material can be sanded and
stained!
How to tell: Real wood fibers
give the strands a rough texture.
and begin extruding while still on the
PLA
setting.
SECTION 4: TIPS & BEST PRACTICES
ABS:
Temp: ABS / FLX Temp
LED Light:
BLUE
Feature: Extruded plastic has
a matte finish. Great for drawing
in the air.
How to tell: Plastic has white
semi-circle ends.
PLA
as you can,
ABS
as you
ABS/
VS
Snipped Ends
Unsnipped Ends
8
EN