3DUpFitters Ender 5 Plus R1 Enclosure Kit Manual de instalación - Página 5

Navegue en línea o descargue pdf Manual de instalación para Impresoras 3D 3DUpFitters Ender 5 Plus R1 Enclosure Kit. 3DUpFitters Ender 5 Plus R1 Enclosure Kit 18 páginas.

Imprimir página
Everything You Wanted to Know About Screwing But
Were Afraid to Ask
Screw
Tool Needed
30-50mm
Hex Cap
3mm Hex Wrench
Head
12mm Hex
3mm Hex Wrench
Cap Head
16mm Hex
3mm Hex Wrench
Cap Head
#6 3/4" Wood
Philips Head
Screw
Screwdriver
The most confusing thing about assembling this enclosure will be which fastener or screw to
use. Luckily it's pretty easy to figure out once you know the system. While the same screw to
use will be detailed in each section of the manual, you probably won't need to refer to it once
you know the secrets.
The most common screw is the 12mm hex cap head screw. The 12mm screws are long
enough to attach things to the acrylic front, top, sides, and back. Each section will describe
exactly which screw to use, read carefully, and use the specified screw for the best results.
The actual length of the "long" screws to attach the fan and or filter will vary depending on the
depth of the particular shipment of fans we happen to get that month. They won't be hard to
spot since they'll be the longest thing in the bags.
Finally, and we can't stress this enough:
D O N 'T
Leave the screws a little loose until the end adjustment phase. During that process, you'll be
hand-tightening until the screws are snug, but you can easily use so much force on the plastic
pieces or the acrylic crack. Please don't be that guy.
Usage
Attach fan/filter, attach large
front latch mounts
Connectors, hinges
Knobs, small latch mounts on
some models
Attach magnetic latch to mount
O V E R T I G H T E N
Copyright 2021 3DUPfitters LLC
Relative Size
T H E
S C R E W S
5