3DUpFitters Ender 5 Plus R1 Enclosure Kit 설치 매뉴얼 - 페이지 5

{카테고리_이름} 3DUpFitters Ender 5 Plus R1 Enclosure Kit에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters Ender 5 Plus R1 Enclosure Kit 18 페이지.

Everything You Wanted to Know About Screwing But

Were Afraid to Ask

Screw

Tool Needed

30-50mm

Hex Cap

3mm Hex Wrench

Head

12mm Hex

3mm Hex Wrench

Cap Head

16mm Hex

3mm Hex Wrench

Cap Head

#6 3/4" Wood

Philips Head

Screw

Screwdriver

The most confusing thing about assembling this enclosure will be which fastener or screw to

use. Luckily it's pretty easy to ﬁgure out once you know the system. While the same screw to

use will be detailed in each section of the manual, you probably won't need to refer to it once

you know the secrets.

The most common screw is the 12mm hex cap head screw. The 12mm screws are long

enough to attach things to the acrylic front, top, sides, and back. Each section will describe

exactly which screw to use, read carefully, and use the speciﬁed screw for the best results.

The actual length of the "long" screws to attach the fan and or ﬁlter will vary depending on the

depth of the particular shipment of fans we happen to get that month. They won't be hard to

spot since they'll be the longest thing in the bags.

Finally, and we can't stress this enough:

D O N 'T

Leave the screws a little loose until the end adjustment phase. During that process, you'll be

hand-tightening until the screws are snug, but you can easily use so much force on the plastic

pieces or the acrylic crack. Please don't be that guy.

Usage

Attach fan/ﬁlter, attach large

front latch mounts

Connectors, hinges

Knobs, small latch mounts on

some models

Attach magnetic latch to mount

O V E R T I G H T E N

Relative Size

T H E

S C R E W S