3DUpFitters Ender 5 Plus R1 Enclosure Kit Manual de instalación - Página 8

Navegue en línea o descargue pdf Manual de instalación para Impresoras 3D 3DUpFitters Ender 5 Plus R1 Enclosure Kit. 3DUpFitters Ender 5 Plus R1 Enclosure Kit 18 páginas.

Imprimir página

Assemble Panels

The front panels are made from thicker 1/4" acrylic to provide more structural rigidity where

needed: the door. Do not try to bend the 1/4" acrylic! The remaining panels are all 1/8".

1. The Front Panel 

Top Left

Bottom Left

Each of the corners of the enclosure will be held together by the connectors pictured

below. There are only two versions, L and R, which can be identiﬁed by the letters

stamped on the inside. The opposite connectors are identical, i.e., Bottom Right is the

same as Top Left. In all cases, the surface of the connector with the cutout pattern

faces front or back.

The front door is designed so that the latches are on the left. Attach the corner

connectors on the backside of the door frame using the provided cap head 12mm

Top Right

Bottom Right