3DUpFitters Ender 5 Plus R1 Enclosure Kit Manual de instalación - Página 9

Navegue en línea o descargue pdf Manual de instalación para Impresoras 3D 3DUpFitters Ender 5 Plus R1 Enclosure Kit. 3DUpFitters Ender 5 Plus R1 Enclosure Kit 18 páginas.

Imprimir página

screws. See the photos below. The top of the connector

should be ﬂush with the acrylic top.

There are also smaller connectors at the top and right

sides when viewed from the front. The front should look

like the picture to the right. 

Locate the magnetic latch and use the wood screws to

attach them to the latch mounts. Hand tighten and

make sure they're secure, but do not over tighten, or

they may strip. The latch can be later adjusted front-to-

back to ensure the door is ﬂush with the door frame.

Each latch mount is attached via one M4 30mm cap

head screw.

Attach the door and door frame hinges using M4 cap

head 12mm screws and nuts. There will be some

play in the hole size so that you can adjust the door

to swing freely.