ClearOne MAX WIRELESS Manual de instalación y funcionamiento - Página 4
Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Teléfono de conferencia ClearOne MAX WIRELESS. ClearOne MAX WIRELESS 11 páginas. Clearone conference phones specification sheet
También para ClearOne MAX WIRELESS: Ficha de datos (2 páginas), Hoja de especificaciones (3 páginas), Folleto (1 páginas), Folleto (2 páginas)
Imprimir página
4
• Observe the proper polarity, or direction, of any battery. Reverse insertion of the battery
pack can result in leakage or explosion.
• Remove the battery pack if you do not plan to use the product for several months at a
time. The batteries could leak over that time.
• Discard any "dead" battery pack as soon as possible because they are likely to leak into
the product.
• Do not store this product or the battery pack in a high temperature area. Battery packs
stored in a freezer or refrigerator should be protected from condensation during storage
and defrosting. Battery packs should be stabilized at room temperature before using.
• Your battery pack is rechargeable and can be recycled once it outlives its usefulness.
Depending upon your local and state law, it might be illegal to dispose of this battery into
a municipal waste system. Check with your local solid waste company for more informa-
tion on your recycling options for the battery pack.
Save these instructions
Getting Started
Connecting your conferencing phone
1. Slide the cover off the battery compartment on the bottom of the pod.
Figure 2. Connecting the battery pack
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Getting Started
Getting Started
2. Connect the battery pack plug into the port in the compartment, insert the
battery pack, and slide the cover back into place.
CAUTION: Use only the battery pack that came with this unit. Replace only with a
!
same or equivalent type recommended by manufacturer. There is risk of
explosion if battery is replaced by an incorrect type.
3. Connect the power adapter to the conferencing pod and plug it into an
electrical outlet. This will charge the battery pack.
Battery packs must be charged at least 15 hours prior to first use.
CAUTION: Use only the power adapter that came with this unit. Using other adapters
!
may damage the unit.
MAX Plus Wireless
Pod Unit
4. Connect one end of the telephone cable into the phone jack on the back of the
base unit and the other end into a wall jack.
In Use and
Power LEDs
Paging button
5.
Connect a recording device to the 2.5mm mono audio jack (if desired).
6. Connect the power cord to the base unit and plug it into an electrical outlet.
The base unit may be located up to 150 feet from the conferencing pod.
The power cord is not included with Max Wireless/MaxAttach Wireless base units that
plug directly into an electrical outlet.
Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760
Figure 3. Connecting
Cable Retainer Unit
power supply
Figure 4. Connecting
the base unit
5