ClearWater mineralpure R-50 Manual de instalación - Página 6

Navegue en línea o descargue pdf Manual de instalación para Sistemas de filtración de agua ClearWater mineralpure R-50. ClearWater mineralpure R-50 16 páginas.

Imprimir página

H). CONNECTING THE ELECTRODE CABLE

Using the Electrode Wire Assembly, connect the two terminal ends to the connectors on each side of the

electrode's connectors by first unscrewing the nuts and then tightening them back on. IT DOES NOT MATTER

WHICH END GETS CONNECTED. Then connect the bare ends to the terminal posts coming out of the power

box. IT DOES NOT MATTER IF YOU ARE CONNECTING TO THE RED OR BLACK POST.

When locating the power source, the unit should turn on and off when the pump and motor does. The best location is the

pool's timer box. If no timer box exists, you can use the pump motor as its power source by removing the back plate.

The unit will automatically work on 115VAC or 230VAC

Below is an example of connecting the control box to a timer box. In this example an Intermatictm timer box is used.

Although most timer boxes are similar they are not exactly the same, please take care when using the provided

information.

230 VAC Operation:

Connect the black (3 stranded) wire cable to the 230 VAC timer box by splicing the 3 wires and connecting the black and

white wires to the LOAD side on the timer box. It makes no difference which colored wire goes to the two load screws.

Connect the green wire to GROUND. When installed properly, the unit should come on and off when the pool pump

goes on and off.

115 VAC Operation:

Connect either the white wire or the black wire to the LOAD side on the timer box. It makes no difference which colored

wire goes to the two load screws. Connect the green wire to ground. When installed properly, the unit should come on

and off when the pool pump goes on and off.

I). CHOOSING THE POWER SOURCE

Connecting the control box to the timer box

TO R-50

CONTROL BOX

TO R-50

CONTROL BOX

Terminal

ends