ClearWater mineralpure R-50 Manual de instalação - Página 6
Procurar online ou descarregar pdf Manual de instalação para Sistemas de filtragem de água ClearWater mineralpure R-50. ClearWater mineralpure R-50 16 páginas.
H). CONNECTING THE ELECTRODE CABLE
Using the Electrode Wire Assembly, connect the two terminal ends to the connectors on each side of the
electrode's connectors by first unscrewing the nuts and then tightening them back on. IT DOES NOT MATTER
WHICH END GETS CONNECTED. Then connect the bare ends to the terminal posts coming out of the power
box. IT DOES NOT MATTER IF YOU ARE CONNECTING TO THE RED OR BLACK POST.
When locating the power source, the unit should turn on and off when the pump and motor does. The best location is the
pool's timer box. If no timer box exists, you can use the pump motor as its power source by removing the back plate.
The unit will automatically work on 115VAC or 230VAC
Below is an example of connecting the control box to a timer box. In this example an Intermatictm timer box is used.
Although most timer boxes are similar they are not exactly the same, please take care when using the provided
information.
230 VAC Operation:
Connect the black (3 stranded) wire cable to the 230 VAC timer box by splicing the 3 wires and connecting the black and
white wires to the LOAD side on the timer box. It makes no difference which colored wire goes to the two load screws.
Connect the green wire to GROUND. When installed properly, the unit should come on and off when the pool pump
goes on and off.
115 VAC Operation:
Connect either the white wire or the black wire to the LOAD side on the timer box. It makes no difference which colored
wire goes to the two load screws. Connect the green wire to ground. When installed properly, the unit should come on
and off when the pool pump goes on and off.
I). CHOOSING THE POWER SOURCE
Connecting the control box to the timer box
TO R-50
CONTROL BOX
TO R-50
CONTROL BOX
6
Terminal
ends