ClearWater OzoneMax OZ-SPA Manual de instalación y funcionamiento - Página 6

Navegue en línea o descargue pdf Manual de instalación y funcionamiento para Equipos de iluminación ClearWater OzoneMax OZ-SPA. ClearWater OzoneMax OZ-SPA 8 páginas. Vacuum-ultraviolet pool ozone systems

Imprimir página

Once everything has been

connected, turn on the power

to the OZ-SPA unit. Make sure

all the connections are

complete and tight.

After installation and turning on

all the equipment, you will see

a frothing (very tiny milk-like

bubbles) action immediately

after the venturi injector. This is

located on the ¼" clear vinyl

hose. These tiny bubbles

should also appear at the

nearest return line and possibly

other return lines. This means

ozone is getting injected into

the pool's water.

Spa Water Chemistry

To achieve optimal performance from the OZ-SPA system, it is recommended the following be

performed prior to initial start-up:

• BACKWASH or clean filter

• Test and adjust water chemical balance to recommendations in the chart below

The amazing thing you will notice about the OZ-SPA system is the clarity of the water, especially if

you are using the MineralPURE ionization system in conjunction with it.

You might initially notice the water getting cloudy the first couple of days. DO NOT BE ALARMED.

THIS IS NORMAL! You will want to clean or backwash your filter after the first

week.

Visual Inspection

You will want to periodically inspect the power box in the evening to ensure the

unit is functioned correctly. Turn the system on temporarily, if needed. The

indicator light, located next to the output connector will glow a nice blue color.

The ozone unit should only be on when the pump is running.

To insure that the venturi injector and bypass are working correctly, simply

observe to see if small bubbles are entering the pool and the "frothing" effect is

taking place in the clear window of the venturi manifold window.

H. Starting the System

water flow

I. Balancing the Spas Water

pH . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7.2 - 7.6

Total Alkalinity (TA) . . . . . . . . . . . . . . . 80 - 120 ppm

Calcium Hardness (CH) . . . . . . . . . . . . 150 - 350 ppm

Total Dissolved Solids (TDS). . . . . . . . 300 - 2000 ppm

Copper Ion Levels . . . . . . . . . . . . . . . . 0.15 - 0.2 ppm

J. Periodic Inspection

water flow

¼" reinforced vinyl hose

Venturi Injector

¾" ID vinyl tubing

(this side should be

showing very

small bubbles)

"Frothing"

Effect

(small bubbles)

Continue on next page >>>