EDIFIER S2000v Manual del usuario - Página 4
Navegue en línea o descargue pdf Manual del usuario para Sistema de altavoces EDIFIER S2000v. EDIFIER S2000v 6 páginas.
Imprimir página
The packing materials are carefully
selected to be of a very high quality
to ensure that the speakers are not
damaged during the transportation.
Please fill in the warranty card when
purchasing the product and make
sure the warranty card is sealed by
the retailer. Please keep the card in
a safe place in case it is needed for
warranty purposes.
Please check the speaker model
number marked on the packing
carton. Please contact the seller as
soon as possible if you find the
speaker is the incorrect model or has
sustained shipping damage. There
are two packages for this product,
please be careful of the high gloss
piano finish during unpacking.
Packing List
Packaged Item List:
Active speaker: 1
None-active speaker: 1
Signal cable for connection of the
two speakers in length of 2.5 M: 1
User Manual: 1
3.5 mm Headphone Plug
/2 P Audio cable: 1
Line control: 1
Rubber feet for underside
protection: 1 set
Speaker Break-in:
As with all high quality loudspeakers, the sonic performance
will change subtly during the initial listening period. If the
speaker has been stored in a cold environment, the damping
compounds and suspension materials of the drive units will
take some time to recover their correct mechanical properties.
The drive unit suspensions will also loosen up during the first
10-15 hours of use. The time taken for the speaker to achieve
its intended performance will vary depending on the previous
storage conditions and how it is to be used. As a general rule,
please allow up to a week for the temperature effects to
stabilize, and 20 hours of average music use for the
mechanical parts of the drivers to attain their intended design
properties. The subtle result of this break-in will be a slightly
warmer and more open sound in general.
Other Service Information:
Avoid exposing the surfaces of the speakers or speaker drivers
to contact with corrosive liquids or gas. Do not place the
speaker system into high temperature, high moisture places, or
where the temperature or moisture fluctuates considerably.
Avoid placement in direct sunlight for long periods of time.
Please dust only with a clean soft cloth. The use of any
chemical cleaners or abrasives is not recommended. For more
stubborn stains a slightly damp soft cloth with a mild dish soap
solution may be used after switching the system Off and
removing the AC plug. DO NOT use lacquer thinner, alcohol,
benzene, thinners, gasoline, or any abrasive cleaner, as the
finish will be damaged. The Edifier Warranty does not cover
such damage to the finish of the speakers. DO NOT use
excessive water on the cleaning cloth due to electrical safety.
The front grille covers can prevent dust buildup forming on the
drivers. As this might affect sound quality slightly, it is better to
keep speakers protected with the grilles left on.
Speaker Break-in: