dji RD2412R Manual del usuario - Página 3
Navegue en línea o descargue pdf Manual del usuario para Accesorios para drones y cuadricópteros dji RD2412R. dji RD2412R 9 páginas. High-precision rotation microwave radar
Imprimir página10. Aircraft speed should not exceed 5 m/s when flying over surfaces at a height of < 2 m. Aircraft
speed should not exceed 7 m/s when flying at a height of ≥ 2 m. Obstacle avoidance will
otherwise be greatly compromised or even disabled.
11. The Microwave Radar will only maintain a fixed distance from vegetation within its working
range (1.5‐3.5 m). Observe the aircraft's distance from the vegetation at all times.
12. Operate with extra caution when flying over inclined surfaces (depending on aircraft speed).
Recommended maximum inclination at different speeds: 10° at 1 m/s, 6° at 3 m/s and 3° at 5
m/s.
13. Please maintain full control of the aircraft at all times. DO NOT rely solely on the DJI MG app.
Keep the aircraft within a visual line of sight observing it at all times. Use your discretion to
operate it manually to avoid obstacles.
14. DO NOT attempt to disassemble any part of the Obstacle Avoidance Radar that has already
been mounted prior to shipping.
15. DO NOT use threadlocker when mounting the radar to avoid damage to the connectors.
Introduction
The High‐Precision Rotation Microwave Radar is designed for DJI Agras MG‐1S Advanced and
Agras MG‐1P series aircraft. It integrates the three altitude stabilization radars and one obstacle
avoidance radar. Its sensitivity has been improved to the twice of the last generation and
omnidirectional detection is supported, which effectively enhance the ability of sensingobstacles
andperceiving the change of terrain. Active obstacle avoidance function makes the radar fully
operational in dusty or nighttime conditions. The radar can sense the horizontal wire with a
radius of 0.5 cm at a distance of 15 meters in front and can effectively reduce the safety risk
caused by common obstacles on farmland, such as wires and tree rods. While improving the
performance of the work, the radar's ingress protection performance is also increased to IP67(IEC
standard 60529), fully adapting to the complicated environment in the field.
Installation
In this example we connect to Agras MG‐1S Advanced. The radar should be mounted to the left
landing gear leg of the aircraft. Hex keys for the following screws are required: M2.5, M3.
1. Slide the three radar connectors on the left landing gear leg to their corresponding horizontal
marks. Rotate the two upper connectors to align the gaps on them to the vertical marks on the
landing gear leg. Then tighten the two M2.5 screws and two M3 screws.