dji RD2412R 사용자 설명서 - 페이지 3

{카테고리_이름} dji RD2412R에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dji RD2412R 9 페이지. High-precision rotation microwave radar

10. Aircraft speed should not exceed 5 m/s when flying over surfaces at a height of < 2 m. Aircraft

speed should not exceed 7 m/s when flying at a height of ≥ 2 m. Obstacle avoidance will

otherwise be greatly compromised or even disabled.

11. The Microwave Radar will only maintain a fixed distance from vegetation within its working

range (1.5‐3.5 m). Observe the aircraft's distance from the vegetation at all times.

12. Operate with extra caution when flying over inclined surfaces (depending on aircraft speed).

Recommended maximum inclination at different speeds: 10° at 1 m/s, 6° at 3 m/s and 3° at 5

m/s.

13. Please maintain full control of the aircraft at all times. DO NOT rely solely on the DJI MG app.

Keep the aircraft within a visual line of sight observing it at all times. Use your discretion to

operate it manually to avoid obstacles.

14. DO NOT attempt to disassemble any part of the Obstacle Avoidance Radar that has already

been mounted prior to shipping.

15. DO NOT use threadlocker when mounting the radar to avoid damage to the connectors.

Introduction

The High‐Precision Rotation Microwave Radar is designed for DJI Agras MG‐1S Advanced and

Agras MG‐1P series aircraft. It integrates the three altitude stabilization radars and one obstacle

avoidance radar. Its sensitivity has been improved to the twice of the last generation and

omnidirectional detection is supported, which effectively enhance the ability of sensingobstacles

andperceiving the change of terrain. Active obstacle avoidance function makes the radar fully

operational in dusty or nighttime conditions. The radar can sense the horizontal wire with a

radius of 0.5 cm at a distance of 15 meters in front and can effectively reduce the safety risk

caused by common obstacles on farmland, such as wires and tree rods. While improving the

performance of the work, the radar's ingress protection performance is also increased to IP67(IEC

standard 60529), fully adapting to the complicated environment in the field.

Installation

In this example we connect to Agras MG‐1S Advanced. The radar should be mounted to the left

landing gear leg of the aircraft. Hex keys for the following screws are required: M2.5, M3.

1. Slide the three radar connectors on the left landing gear leg to their corresponding horizontal

marks. Rotate the two upper connectors to align the gaps on them to the vertical marks on the

landing gear leg. Then tighten the two M2.5 screws and two M3 screws.