akkuteam VAS 5581 Manual de instrucciones - Página 13
Navegue en línea o descargue pdf Manual de instrucciones para Instrumentos de medida akkuteam VAS 5581. akkuteam VAS 5581 17 páginas. Hv measurement adapter
Imprimir página
Operating Instructions
HV Measurement Adapter VAS 5581
4.6.2 Battery status indicator and charging the battery
After switching on the VAS 5581 without a connected power supply, the
charge status of the battery is indicated with 3 LEDs next to the battery
symbols. Without an installed battery, the VAS 5581 can only be started
with a power supply connected and plugged into a power outlet.
When no battery is installed in the measurement adapter, all 3 battery
LEDs light up for 15 seconds and then go dark after the measurement
adapter was started.
The charging of the built-in battery will start automatically when the
power supply is connected. The green flashing LED with the battery
symbol "Full Battery" indicates the started charging process. Whenever
the power supply is connected the charging mode will be started when
a battery is installed even when the device is switched off. The regular
charging time of a fully discharged battery is about 12 hours. Partial
charges to maintain the currently required operability are possible at
any time.
The 3 LEDs indicate the charging status when operating the measurement
adapter without a power supply and with the battery installed.
When the red, the yellow and the green LED with the "Full Battery"
symbol is lit, the battery is at a charging status of 100 %. When only
the red and the yellow LED with the "Half-Full Battery" symbol is lit, the
battery is at a charging status of less than 60 %. When only the red
LED with the "Empty Battery" symbol is lit, the battery is at a charging
status of less than 30%.
The cells of the built-in battery need a balancing regularly. This
equalization charge starts automatically when the power supply is
connected. Other features of the device will not be affected. The
balancing will not be signaled separately. It is indicated by the flashing
LED "Full Battery", too. For an efficient balancing the power supply
should stay connected to a VAS 5581 with built-in battery for at least
12 hours. At least every 10 complete discharges of the battery this
special charge should take place during the usage of the VAS 5581.
www.akkuteam.de
24
To visualize the finished balancing while the power supply is connected
the flashing LED will change into a permanent shine after 12 hours.
4.7 Function description
NOTE! As a result of firmware updates, your device may
have functions available that are not described in this
operating manual, or vice-versa. Moreover, individual
graphics may show operator controls that differ slightly from
those on your device. The function of the operator controls is
nevertheless the same.
NOTE! The close contactor function has the effect that KL30C
is supplied with 12V from the BMS and that the pilot line is
closed. You can find other framework conditions in the repair
guidelines.
WARNING! Inappropriate operation can result in serious
bodily injury and property damage. Only perform the
described functions after having read and understood the
following documents:
– this operating manual
– all operating manuals for the system components,
specifically the safety instructions
Insert the diagnostics connector or the radio head (VCI, e.g. VAS 5054)
into the diagnostics port on the VAS 5581. Connect the vehicle-specific
adapter cable into the 10-pin port of the measurement adapter and
connect the other end with the BMS on the HV battery.
The adapter cable specified for use is described in the repair guidelines
or in the guided fault finding. Employing an incorrect adapter cable
may damage the vehicle. The VAS 5581/1 adapter cable is included in
the contents supplied together with the VAS 5581.
25
V 1.0