akkuteam VAS 5581 Gebruiksaanwijzing - Pagina 13

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} akkuteam VAS 5581. akkuteam VAS 5581 17 pagina's. Hv measurement adapter

Pagina afdrukken

Operating Instructions

HV Measurement Adapter VAS 5581

4.6.2 Battery status indicator and charging the battery

After switching on the VAS 5581 without a connected power supply, the

charge status of the battery is indicated with 3 LEDs next to the battery

symbols. Without an installed battery, the VAS 5581 can only be started

with a power supply connected and plugged into a power outlet.

When no battery is installed in the measurement adapter, all 3 battery

LEDs light up for 15 seconds and then go dark after the measurement

adapter was started.

The charging of the built-in battery will start automatically when the

power supply is connected. The green flashing LED with the battery

symbol "Full Battery" indicates the started charging process. Whenever

the power supply is connected the charging mode will be started when

a battery is installed even when the device is switched off. The regular

charging time of a fully discharged battery is about 12 hours. Partial

charges to maintain the currently required operability are possible at

any time.

The 3 LEDs indicate the charging status when operating the measurement

adapter without a power supply and with the battery installed.

When the red, the yellow and the green LED with the "Full Battery"

symbol is lit, the battery is at a charging status of 100 %. When only

the red and the yellow LED with the "Half-Full Battery" symbol is lit, the

battery is at a charging status of less than 60 %. When only the red

LED with the "Empty Battery" symbol is lit, the battery is at a charging

status of less than 30%.

The cells of the built-in battery need a balancing regularly. This

equalization charge starts automatically when the power supply is

connected. Other features of the device will not be affected. The

balancing will not be signaled separately. It is indicated by the flashing

LED "Full Battery", too. For an efficient balancing the power supply

should stay connected to a VAS 5581 with built-in battery for at least

12 hours. At least every 10 complete discharges of the battery this

special charge should take place during the usage of the VAS 5581.

www.akkuteam.de

To visualize the finished balancing while the power supply is connected

the flashing LED will change into a permanent shine after 12 hours.

4.7 Function description

NOTE! As a result of firmware updates, your device may

have functions available that are not described in this

operating manual, or vice-versa. Moreover, individual

graphics may show operator controls that differ slightly from

those on your device. The function of the operator controls is

nevertheless the same.

NOTE! The close contactor function has the effect that KL30C

is supplied with 12V from the BMS and that the pilot line is

closed. You can find other framework conditions in the repair

guidelines.

WARNING! Inappropriate operation can result in serious

bodily injury and property damage. Only perform the

described functions after having read and understood the

following documents:

– this operating manual

– all operating manuals for the system components,

specifically the safety instructions

Insert the diagnostics connector or the radio head (VCI, e.g. VAS 5054)

into the diagnostics port on the VAS 5581. Connect the vehicle-specific

adapter cable into the 10-pin port of the measurement adapter and

connect the other end with the BMS on the HV battery.

The adapter cable specified for use is described in the repair guidelines

or in the guided fault finding. Employing an incorrect adapter cable

may damage the vehicle. The VAS 5581/1 adapter cable is included in

the contents supplied together with the VAS 5581.

V 1.0