DK2 12SPS24 Instrucciones de montaje y uso - Página 5
Navegue en línea o descargue pdf Instrucciones de montaje y uso para Cabrestantes DK2 12SPS24. DK2 12SPS24 20 páginas. Electrical winch
properly aligned. Proper alignment of the winch will allow even distribution of
the full rated load.
2. Start by connecting the Roller Fairlead (Part# 120700) to the Mounting Channel
(Part# 120025) using 2 each of the Cap Bolt M10 X 35 (Part# 120002), Flat
Washer (Part# 120004), Lock Washer (Part# 120003) and securing with M10
Nut(Part# 120024) (Make sure the bolt is placed through the mounting channel
and roller fairlead from inside the channel. This will allow enough clearance for
the winch to be placed in the channel without obstruction.)
3. Assemble the winch to the Mounting Channel (Part# 120025) by first pulling
and releasing the clutch knob to "Off" position (Free Spooling). Pull out a few
inches of cable from the drum and feed the wire loop through the opening in the
front of the mounting channel and roller fairlead. Now, using the remaining
M10 x 35 Cap Bolts (Part# 120002), Flat Washer (Part# 120004), Lock Washer
(Part# 120003) and M10 Nut (Part# 120005) secure the winch to the mounting
channel.
4. Connect the battery and motor leads as the drawing above every type of winch
is different each other.
5. Connect the winch motor leads as detailed below:
CAUTION –
Wear eye protection during installation and remove all jewelry. Do not lean over
battery while making connections.
Batteries contain gases which are flammable and explosive.
5