DK2 12SPS24 Instruções de montagem e funcionamento - Página 5

Procurar online ou descarregar pdf Instruções de montagem e funcionamento para Guinchos DK2 12SPS24. DK2 12SPS24 20 páginas. Electrical winch

properly aligned. Proper alignment of the winch will allow even distribution of

the full rated load.

2. Start by connecting the Roller Fairlead (Part# 120700) to the Mounting Channel

(Part# 120025) using 2 each of the Cap Bolt M10 X 35 (Part# 120002), Flat

Washer (Part# 120004), Lock Washer (Part# 120003) and securing with M10

Nut(Part# 120024) (Make sure the bolt is placed through the mounting channel

and roller fairlead from inside the channel. This will allow enough clearance for

the winch to be placed in the channel without obstruction.)

3. Assemble the winch to the Mounting Channel (Part# 120025) by first pulling

and releasing the clutch knob to "Off" position (Free Spooling). Pull out a few

inches of cable from the drum and feed the wire loop through the opening in the

front of the mounting channel and roller fairlead. Now, using the remaining

M10 x 35 Cap Bolts (Part# 120002), Flat Washer (Part# 120004), Lock Washer

(Part# 120003) and M10 Nut (Part# 120005) secure the winch to the mounting

channel.

4. Connect the battery and motor leads as the drawing above every type of winch

is different each other.

5. Connect the winch motor leads as detailed below:

CAUTION –

Wear eye protection during installation and remove all jewelry. Do not lean over

battery while making connections.

Batteries contain gases which are flammable and explosive.