Artist Guitars BAH200 Manual - Página 9
Navegue en línea o descargue pdf Manual para Amplificador Artist Guitars BAH200. Artist Guitars BAH200 12 páginas.
BAH200
5. Direct Output Level
This determines the level of the direct output.
6. Send and Return
The effects loop send and return allows you to plug in pedals but have
them either after the preamp in the signal chain or before, depending
on the position of the Pre/Post switch (see 7). This means your bass
signal will go to the preamp first (if the switch is pushed in), and then
can be sent out to a pedal chain using the "Send" output. From there, it
would go out of the pedal chain and back into the amp via the "Return"
input. This allows you to keep distortion and overdrive pedal signals
separate from modulation such as reverb and delay.
Pre/Post Switch
7.
This determines the position of the Send/Return loop in the signal
chain. If it's not pushed in, it'll be before the preamp stage. If it is
pushed in, it'll be after the preamp stage.
8. Ground/Lift Switch
The ground lift switch eliminates unwanted hum and buzz by
interrupting the ground loops between equipment, preventing current
flow along the cable shield between two devices. The switch
disconnects pin 1 on the XLR jack, which is connected to the braid or
foil shield in the cable and acts as the ground point of the circuit.
9. Tuner Output
This is where you can plug in a tuner pedal to tune your bass.
10. Footswitch Input
This allows you to plug in a footswitch to be able to control the mute
function on the amplifier.
11. Speakon Speaker Output
This output is used to connect the amplifier head to a speaker box. This
connection is for speaker stacks that use a Speakon connector.
9