- ページ 9

アンプ Artist Guitars BAH200のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Artist Guitars BAH200 12 ページ。

BAH200

5. Direct Output Level

This determines the level of the direct output.

6. Send and Return

The effects loop send and return allows you to plug in pedals but have

them either after the preamp in the signal chain or before, depending

on the position of the Pre/Post switch (see 7). This means your bass

signal will go to the preamp ﬁrst (if the switch is pushed in), and then

can be sent out to a pedal chain using the "Send" output. From there, it

would go out of the pedal chain and back into the amp via the "Return"

input. This allows you to keep distortion and overdrive pedal signals

separate from modulation such as reverb and delay.

Pre/Post Switch

This determines the position of the Send/Return loop in the signal

chain. If it's not pushed in, it'll be before the preamp stage. If it is

pushed in, it'll be after the preamp stage.

8. Ground/Lift Switch

The ground lift switch eliminates unwanted hum and buzz by

interrupting the ground loops between equipment, preventing current

ﬂow along the cable shield between two devices. The switch

disconnects pin 1 on the XLR jack, which is connected to the braid or

foil shield in the cable and acts as the ground point of the circuit.

9. Tuner Output

This is where you can plug in a tuner pedal to tune your bass.

10. Footswitch Input

This allows you to plug in a footswitch to be able to control the mute

function on the ampliﬁer.

11. Speakon Speaker Output

This output is used to connect the ampliﬁer head to a speaker box. This

connection is for speaker stacks that use a Speakon connector.