DK2 Power OPC503 Manual de montaje - Página 11

Navegue en línea o descargue pdf Manual de montaje para Astilladora DK2 Power OPC503. DK2 Power OPC503 13 páginas. Chipper shredder top loading
También para DK2 Power OPC503: Manual de montaje (15 páginas), Manual de instrucciones (14 páginas), Manual de instalación (20 páginas)

Imprimir página
DK2 Power OPC503 Manual de montaje
OPERATION – BEFORE TURNING KEY AND PULL STARTING ENGINE
CLEAR AREA OF ALL PEOPLE AND PROPERTY THAT COULD BE DAMAGED. THINK
SAFETY. CHIPS ARE FLYING PROJECTILES AND CAN CAUSE INJURY.
WEAR SAFETY GLASSES, HEARING PROTECTION, AND GLOVES
DO NOT WEAR LOOSE FITTING CLOTHES THAT COULD GET STUCK IN THE MACHINE
MOVING PARTS, ONLY CHIP WOOD, CHILDREN SHOULD NOT RUN THIS EQUIPMENT,
STAY ALERT OF YOUR SURROUNDING AND PERSONS THAT COULD APEAR IN THE
CHIP PATH WHILE YOU ARE WORKING.
UNIT IS DIRECT DRIVE. NO CLUTCH
TO SLIP OR BURN UP.
Before starting make sure all chutes are clear of branches as the cutting wheel will
turn as you pull the recoil starter. Cutter wheel must be free to turn when starting.
PERFORMANCE OPERATION -
Feed larger trees upto 3 inches in diameter slowly into the tubular feed chute
allowing the cutter wheel to regain speed. Shoving a tree into the cutter wheel will
stall the machine and damage the cutters or drive shaft.
Feed twigs, leaves, and branches upto 1 inch dia into the top hopper.
Wear gloves, as the cutter will grab the branches and pull them into the machine
and from your hands. NEVER PLACE HANDS INTO THE TOP FEEDER.
To clear the top feeder turn the key off, remove it, unplug the spark plug.
Be safe, the cutter on this machine are high speed and very sharp.
SET BOTH OF YOUR WHEEL BRAKE PINS to STABILIZE MACHINE DURING OPERATION.
READ AND OBEY ALL WARNING LABELS ON THIS MACHINE.