DK2 Power OPC503 조립 설명서 - 페이지 11

{카테고리_이름} DK2 Power OPC503에 대한 조립 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DK2 Power OPC503 13 페이지. Chipper shredder top loading
DK2 Power OPC503에 대해서도 마찬가지입니다: 조립 설명서 (15 페이지), 사용 설명서 (14 페이지), 설치 매뉴얼 (20 페이지)

페이지 인쇄
DK2 Power OPC503 조립 설명서
OPERATION – BEFORE TURNING KEY AND PULL STARTING ENGINE
CLEAR AREA OF ALL PEOPLE AND PROPERTY THAT COULD BE DAMAGED. THINK
SAFETY. CHIPS ARE FLYING PROJECTILES AND CAN CAUSE INJURY.
WEAR SAFETY GLASSES, HEARING PROTECTION, AND GLOVES
DO NOT WEAR LOOSE FITTING CLOTHES THAT COULD GET STUCK IN THE MACHINE
MOVING PARTS, ONLY CHIP WOOD, CHILDREN SHOULD NOT RUN THIS EQUIPMENT,
STAY ALERT OF YOUR SURROUNDING AND PERSONS THAT COULD APEAR IN THE
CHIP PATH WHILE YOU ARE WORKING.
UNIT IS DIRECT DRIVE. NO CLUTCH
TO SLIP OR BURN UP.
Before starting make sure all chutes are clear of branches as the cutting wheel will
turn as you pull the recoil starter. Cutter wheel must be free to turn when starting.
PERFORMANCE OPERATION -
Feed larger trees upto 3 inches in diameter slowly into the tubular feed chute
allowing the cutter wheel to regain speed. Shoving a tree into the cutter wheel will
stall the machine and damage the cutters or drive shaft.
Feed twigs, leaves, and branches upto 1 inch dia into the top hopper.
Wear gloves, as the cutter will grab the branches and pull them into the machine
and from your hands. NEVER PLACE HANDS INTO THE TOP FEEDER.
To clear the top feeder turn the key off, remove it, unplug the spark plug.
Be safe, the cutter on this machine are high speed and very sharp.
SET BOTH OF YOUR WHEEL BRAKE PINS to STABILIZE MACHINE DURING OPERATION.
READ AND OBEY ALL WARNING LABELS ON THIS MACHINE.