Alumax SPEEDSTALL 794S Series Manual de instrucciones de instalación - Página 7

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Recinto Alumax SPEEDSTALL 794S Series. Alumax SPEEDSTALL 794S Series 9 páginas. Shower enclosure

Imprimir página

Snap the fillers [P] into the curb assembly [A] and

header assembly [D] between the door jambs with the

raised lip to the exterior and the pivot holes toward the

pivot jamb [M]. Center the curb filler in the curb between

the pivot and strike jamb [N] (use masking tape to hold in

position).

NOTE: The snap-in fillers should be exactly 3/8" longer

than the door panel width.

Pull the bottom end of the pivot jamb [M] tight to

the curb filler [P] and plumb the jamb. Drill two 1/8"

holes thru the pivot jamb and into the 135° post [J] in line

with the screws in the head and curb and approximately

1/4" vertically from the ends of the jamb. Drill a third

hole centered between the first two. Attach the pivot

jamb permanently with three #8 x 1/4" truss head screws

[C].

Slide the header filler [P] tight against the pivot jamb.

Push the strike jamb [N] tight against the fillers top and

bottom. With the pivot jamb plumb and both fillers tight

between the two door jambs, the strike jamb also will be

plumb and parallel to the pivot jamb. Attach the strike

jamb to the other 135° post [J] in the same manner as the

pivot jamb.

Insert the two #10-24 x 7/16" square head set

screws [W] into the threaded holes in the pivot blocks in

the top and bottom rails of the glazed door panel [L].

Position the pivot pins 1 1/2" from the pivot side of the door

(the side opposite the magnetic strip). Tighten the set

screws just enough to prevent the pivot blocks from

moving (finger tight plus a quarter turn). A 3/16" wrench

(not supplied by A

LUMAX

Press the white nylon spacer [X] over the bottom pivot pin

on the door panel.

) will fit the set screw heads

Page 7 of 9

G03711103

8-22-06