Alumax SPEEDSTALL 794S Series Manual de instrucciones de instalación - Página 9

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Recinto Alumax SPEEDSTALL 794S Series. Alumax SPEEDSTALL 794S Series 9 páginas. Shower enclosure

Imprimir página

Attach the interior door handle [BB] and the

exterior door handle [CC] to the door panel [L] with two

#6-32 x 1 1/4" round head screws [DD].

Close the door and check the clearance with the strike

jamb [N]. If necessary, loosen the set screws [W] on the

top and bottom slide bars and adjust the door panel to align

the strike magnets. When the door panel is properly

aligned, tighten the set screws securely.

Carefully caulk the interior jamb-to-wall and curb-

to-base joints. Caulk the small gaps at the corners of the

side panels (see arrow on illustration) to prevent water

infiltration. For appearance, you may wish to caulk the

exterior joints as well.

We recommend that you wait twenty-four hours before

the first shower to allow the caulking to cure properly.

To keep your Alumax Bath Enclosure looking like new we recommend the Alumax

ShowerBright Consumer Maintenance Kit. The Consumer Maintenance Kit surface should be

applied every 45 to 60 days. To purchase or for more information contact your dealer. Our

dealers have the materials to do a professional ShowerBright restoration. For best results

professional restorations should be performed a maximum of once every three months. Contact

your dealer for more information. New units with factory supplied ShowerBright coating have

a limited lifetime warranty. For daily cleaning the simplest and preferred method is to wash the

unit with clean water and dry with a soft cloth. Do not use scouring pads, sharp instruments,

or acid-based cleansers to clean the unit.

Consumer kits will be sold direct, consumers will need to go to dealers for professional

restoration and new units can be purchased with the permanent coating. Consumer kit

materials need to be applied every 45 to 60 days, pro materials to be applied once quarterly max

and factory has limited lifetime.

Page 9 of 9

G03711103

8-22-06