Alunar R100-01 Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Impresoras 3D Alunar R100-01. Alunar R100-01 11 páginas. Lesser alunar 3d printers

Alunar 3D Printers

PRINT MATERIALS

Printers can use two different types of print materials: PLA and ABS. Each material

has unique benefits and you can guide your selection based on the properties your

part requires.

PLA

This is a hard plastic that has a low environmental impact. It is derived from

renewable, starch-based resources.

We recommend using PLA when printing extra-large parts on printer as it is a

more stable print material.

PLA is the optimal support material for industrial ABS parts. PLA has the ability to

dissolve away in caustic soda solutions supported by an ultra-sonic tank.

ABS

This is a well-known plastic known for its strength and industrial properties.

As a build material, ABS is good for both small and large parts.

ABS works as an excellent support material for extra-large PLA parts.

3. UNPACKING & INSTALLING

3.1 Unpacking

A. Unpacking the item, and put the printer on a level table. 4 bottom knobs will help

to fine-adjust.

B. Connect the Filament Bracket, and put the PLA on it.

C. Put one print plate on the bed. Connect the power cable and press the switch to

start.

D. Cut filament at an oblique angle. Press and holding down the clip. Plug in the

filament through tube to the nozzle.