Alunar R100-01 사용자 설명서 - 페이지 5

{카테고리_이름} Alunar R100-01에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alunar R100-01 11 페이지. Lesser alunar 3d printers

Alunar 3D Printers

PRINT MATERIALS

Printers can use two different types of print materials: PLA and ABS. Each material

has unique benefits and you can guide your selection based on the properties your

part requires.

PLA

This is a hard plastic that has a low environmental impact. It is derived from

renewable, starch-based resources.

We recommend using PLA when printing extra-large parts on printer as it is a

more stable print material.

PLA is the optimal support material for industrial ABS parts. PLA has the ability to

dissolve away in caustic soda solutions supported by an ultra-sonic tank.

ABS

This is a well-known plastic known for its strength and industrial properties.

As a build material, ABS is good for both small and large parts.

ABS works as an excellent support material for extra-large PLA parts.

3. UNPACKING & INSTALLING

3.1 Unpacking

A. Unpacking the item, and put the printer on a level table. 4 bottom knobs will help

to fine-adjust.

B. Connect the Filament Bracket, and put the PLA on it.

C. Put one print plate on the bed. Connect the power cable and press the switch to

start.

D. Cut filament at an oblique angle. Press and holding down the clip. Plug in the

filament through tube to the nozzle.