ALUZ ZIBI A1 Series Manual - Página 8
Navegue en línea o descargue pdf Manual para Equipos de iluminación ALUZ ZIBI A1 Series. ALUZ ZIBI A1 Series 11 páginas. Surface zuco pivot bios illuminated
También para ALUZ ZIBI A1 Series: Manual de instrucciones de instalación (12 páginas), Manual (13 páginas), Manual (11 páginas), Manual de instrucciones de instalación (11 páginas)
Imprimir página1
Determine number of louvers needed. Louvers are available in 1' increments.
Specify total length of reflectors needed.
2
Position louvers on luminaires.
Set Screw
3
Install 3 set screws on each louver to secure in place.
Do not over-tighten set screws
Set Screw
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A1 Series | Surface
ZIBI Pivot RGBW
(A1-ZIBI-PVT-RGBW)
866.ALUZ.LTG | 714.535.7900
4
If applicable, connect disconnects between luminaires. Slide shrink tube over
connectors and apply heat. The shrink tube will shrink down, sealing the
connectors. Apply silicone around sealed connectors for a stronger seal.
5
Mount luminaires at least 12" away from the wall.
Page 8 of 11
Louver (A1-ZIBI-PVT-LVR)
Shrink Tube
2"
Apply Heat
12"
Min. from Wall
Installation Instructions
4 / 29 / 2022 / Rev 2