ALUZ ZIBI A1 Series Руководство - Страница 8
Просмотреть онлайн или скачать pdf Руководство для Осветительное оборудование ALUZ ZIBI A1 Series. ALUZ ZIBI A1 Series 11 страниц. Surface zuco pivot bios illuminated
Также для ALUZ ZIBI A1 Series: Руководство по установке (12 страниц), Руководство (13 страниц), Руководство (11 страниц), Руководство по установке (11 страниц)
Печатать страницу1
Determine number of louvers needed. Louvers are available in 1' increments.
Specify total length of reflectors needed.
2
Position louvers on luminaires.
Set Screw
3
Install 3 set screws on each louver to secure in place.
Do not over-tighten set screws
Set Screw
1170 N Red Gum St, Anaheim, CA 92806
aluz.lighting
© ALUZ All Rights Reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
A1 Series | Surface
ZIBI Pivot RGBW
(A1-ZIBI-PVT-RGBW)
866.ALUZ.LTG | 714.535.7900
4
If applicable, connect disconnects between luminaires. Slide shrink tube over
connectors and apply heat. The shrink tube will shrink down, sealing the
connectors. Apply silicone around sealed connectors for a stronger seal.
5
Mount luminaires at least 12" away from the wall.
Page 8 of 11
Louver (A1-ZIBI-PVT-LVR)
Shrink Tube
2"
Apply Heat
12"
Min. from Wall
Installation Instructions
4 / 29 / 2022 / Rev 2