DNP DS40 Manual de mantenimiento - Página 3

Navegue en línea o descargue pdf Manual de mantenimiento para Impresora DNP DS40. DNP DS40 6 páginas. Photo imaging
También para DNP DS40: Referencia rápida (6 páginas), Manual de inicio rápido (8 páginas), Manual de reenvasado (2 páginas)

Ribbon

Once the paper has been changed & the lid

closed you will be able to access the ribbon tray.

Grasp the black 'handle' of the ribbon tray & pull

upwards (Figure 5).

Remove & discard the used ribbon from the

ribbon tray. DO NOT DISCARD THE RIBBON

TRAY.

Inset the new ribbon into the tray, Purple (supply)

spool to the front & orange (take up/waste) to the

rear with the ribbon going over the top of the

spools. Not the ribbon is designed to only go into

the holder one specific way (Figure 6). There is

a diagram on the inside of the tray if you require

any guidance.

Ensure there is no slack in the ribbon by gently

winding the supply side of the ribbon to tighten.

Replace the ribbon tray into the printer by sliding

the entire assembly into the printer mechanism.

Replace the emptied off-cut drawer then close the printer drawer by pushing it in

until it clicks shut. The LED's will flash and the printer will initialize. The printer

will produce four offcuts as part of this process. Once this has finished your printer

is ready to go!

Figure 5 - Ribbon tray rem oval/replac ement

Figure 6 - correctly seated ribbon in tray

mechanism