3M S15I - Digital Projector SVGA LCD Manual de seguridad del producto - Página 12
Navegue en línea o descargue pdf Manual de seguridad del producto para Proyector 3M S15I - Digital Projector SVGA LCD. 3M S15I - Digital Projector SVGA LCD 15 páginas. Multimedia projector
También para 3M S15I - Digital Projector SVGA LCD: Folleto y especificaciones (4 páginas), Especificaciones (2 páginas), Manual de inicio rápido (4 páginas)
Imprimir página
For maximum lamp life, do not strike or drop, improperly handle, or scratch the lamp glass.
Also, do not install an old or previously used lamp.
1. Remove lamp access door: Please loosen the screw (marked by arrow) (1). Then, unhook the
claws of the lamp door (2), and remove the lamp door (3).
2. Retaining screws: Use a screwdriver to unscrew the lamp module retaining screws. (4)
All lamp module screws must be loosened. These screws are self-containing screws that
cannot be removed from the lamp module or access door.
3. Remove lamp module: Slowly pick up the lamp module by the handles. (5)
4. Insert lamp module: Carefully insert (5) the new lamp module. Ensure that it is fully seated.
Tighten the lamp module retaining screws (4) to secure the lamp module in place.
Optional Lamp: 78-6969-9812-5 (Contact 3M customer Service.)
Insert the hinge tabs on the bottom of the lamp access door (6), then
two claws (7)
Reset the lamp operation hours. See "Reset Lamp Hours" for details.
(1) Screw marked
by arrow
(2) Claws
(3) Lamp access door
12
Note
Note
Note
(4) Screws marked
by arrow
(5) Handles
3M™ Multimedia Projector S15i Product Safety Guide
push the center point of
(6) Tab
(7) Center point of
claws
© 3M 2006