DockCraft DS300 Instrucciones de montaje, instalación, configuración y funcionamiento - Página 9

Navegue en línea o descargue pdf Instrucciones de montaje, instalación, configuración y funcionamiento para Equipamiento náutico DockCraft DS300. DockCraft DS300 12 páginas.

Imprimir página

If Clevis Pin with Circular Retaining Ring in Hole 2 or 4 of Pivot Lateral is seated in the Bottom Slot

If on your unit Tightly Wrap Safety Strap

around Pivot Lateral and Dock Mount

Now that the installation is complete, it is now time to SETUP your Kayak Rack to "fit" your Kayak.

Webbing Length Adjustment :

As a result of the assembly procedure, the mark on the webbing should be located at the cam buckle.

This setting is a nominal setting for kayaks with a width of 27 to 29 inches. Based on the width and contour of

your kayak, this setting may vary. When loading, with the kayak in the water, the handle should be a couple of

inches above the outside edge of the kayak.

This setting is for 2 purposes:

1 - To accommodate the size

and contour of your Kayak

2 - To allow your Kayak to sit at

an angle to minimize rain

entering the Kayak and

therefore collect in the cockpit

Insert 2

Clevis Pin through hole in bracket

and secure with

"R" Retaining Clip on opposite side.

The Installation is Complete

SETUP of "The DockSider"

Page 9 of 12

Rotate the Latch Plates to secure in Storage Position

Latch Plate

Kayak End

Pull to Lengthen

Loose End

Pull to Shorten