Akrobat PRIMUS FLAT Manual de instalación y uso - Página 6

Navegue en línea o descargue pdf Manual de instalación y uso para Deportes y aire libre Akrobat PRIMUS FLAT. Akrobat PRIMUS FLAT 10 páginas. Trampoline 17 x 10 ft
También para Akrobat PRIMUS FLAT: Manual de instalación y uso (17 páginas)

Imprimir página

Placing the trampoline into the pit

Carefully place the trampoline on the

ledge covered with the weed protection.

Fill the remaining free space around the

trampoline with the remaining soil, then

cut off the excess material of the weed

protection.

Check that the trampoline is well levelled.

You may want to remove the trampoline

to make any adjustments to the height

that the frame is sitting on. Aim for the

trampoline jumping mat to sit ﬂush to

the ground.

As this trampoline is very heavy we

suggest to have at least four people at

installation.

There should be no gap between the

ground and your trampoline.

Finally, re-lay the saved soil around the

trampoline and compact down as much

as possible.

Inserting the foam into the frame pad

Inside the package you will ﬁnd two parts of gray foam. This foam needs to be inserted into

PVC pocket on the bottom side, located exactly in the middle of long side of the frame pad. Be

carefull to place it so that round cut-out circles on the foam are on the outer side of the pad (this

holes are made so that later you can ﬁt poles into the enclosure sockets).

The foam must be completely in the cover, this can take some effort. The operation is similar

to a pillowcase. The foam may therefore no longer be visible after installation and must be fully

mounted in the PVC cover.

INSTALLATION AND USER MANUAL - Primus Flat RECTANGULAR

Attaching the frame pad

Lay the safety pad on top of the trampoline with the eyelets facing up. Insert the elastic

toggles through the eyelets so the loop end of the elastic faces outwards and the toggle end

is on the inside.

Flip the frame pad over and pull the

elastic band around the frame. Insert

the toggle into the loop, then rotate the

toggle inwards to secure it. Repeat with

all frame pad elastics.

Important:

The frame pad must cover the

entire frame and all springs.

The last step to secure the frame pad to

the trampoline is placing springs into the

"spring loops". You will ﬁnd 8 of them on

the underside of the frame pad where

each pad section joins the next one.

Remove a single spring under every loop,

slip it through the loop and reattach to

the frame. Repeat with all loops. This will

prevent the front of the pads from lifting

up.

AKROBAT HINT:

If you ﬁnd it too difﬁcult to get the toggles in

place, wedge a screwdriver carefully between

the frame and PVC panel to attach the toggle.

Using a ﬂat-head screwdriver (or similar), push

the loop end between the wall panel and frame.

Insert the toggle from underneath and rotate

to secure. Repeat with all elastics.