Akrobat PRIMUS FLAT Kurulum ve Kullanım Kılavuzu - Sayfa 6
Spor & Kamp; Açık Hava Akrobat PRIMUS FLAT için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Akrobat PRIMUS FLAT 10 sayfaları. Trampoline 17 x 10 ft
Ayrıca Akrobat PRIMUS FLAT için: Kurulum ve Kullanım Kılavuzu (17 sayfalar)
Placing the trampoline into the pit
Carefully place the trampoline on the
7
ledge covered with the weed protection.
Fill the remaining free space around the
trampoline with the remaining soil, then
cut off the excess material of the weed
protection.
Check that the trampoline is well levelled.
You may want to remove the trampoline
to make any adjustments to the height
that the frame is sitting on. Aim for the
trampoline jumping mat to sit flush to
the ground.
As this trampoline is very heavy we
suggest to have at least four people at
installation.
There should be no gap between the
ground and your trampoline.
Finally, re-lay the saved soil around the
trampoline and compact down as much
as possible.
Inserting the foam into the frame pad
Inside the package you will find two parts of gray foam. This foam needs to be inserted into
8
PVC pocket on the bottom side, located exactly in the middle of long side of the frame pad. Be
carefull to place it so that round cut-out circles on the foam are on the outer side of the pad (this
holes are made so that later you can fit poles into the enclosure sockets).
The foam must be completely in the cover, this can take some effort. The operation is similar
to a pillowcase. The foam may therefore no longer be visible after installation and must be fully
mounted in the PVC cover.
10
INSTALLATION AND USER MANUAL - Primus Flat RECTANGULAR
Attaching the frame pad
Lay the safety pad on top of the trampoline with the eyelets facing up. Insert the elastic
9
toggles through the eyelets so the loop end of the elastic faces outwards and the toggle end
is on the inside.
Flip the frame pad over and pull the
10
elastic band around the frame. Insert
the toggle into the loop, then rotate the
toggle inwards to secure it. Repeat with
all frame pad elastics.
Important:
The frame pad must cover the
entire frame and all springs.
The last step to secure the frame pad to
11
the trampoline is placing springs into the
"spring loops". You will find 8 of them on
the underside of the frame pad where
each pad section joins the next one.
Remove a single spring under every loop,
slip it through the loop and reattach to
the frame. Repeat with all loops. This will
prevent the front of the pads from lifting
up.
AKROBAT HINT:
If you find it too difficult to get the toggles in
place, wedge a screwdriver carefully between
the frame and PVC panel to attach the toggle.
Using a flat-head screwdriver (or similar), push
the loop end between the wall panel and frame.
Insert the toggle from underneath and rotate
to secure. Repeat with all elastics.
11