Akrobat PRIMUS FLAT Kurulum ve Kullanım Kılavuzu - Sayfa 5

Spor & Kamp; Açık Hava Akrobat PRIMUS FLAT için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. Akrobat PRIMUS FLAT 10 sayfaları. Trampoline 17 x 10 ft
Ayrıca Akrobat PRIMUS FLAT için: Kurulum ve Kullanım Kılavuzu (17 sayfalar)

Sayfayı Yazdır
Digging the trampoline pit
Position the frame on the location you chose and mark the position on the ground. It's
4
best to mark out a hole a bit wider than the diameter of your trampoline.
This will make it easier for you to put the frame in and find the right level. Dig the pit to
the following dimensions:
TRAMPOLINE SIZE
Dimension A:
Trampoline size
17 x 10 ft / 518 x 305 cm
478 x 265 cm / 15'8'' x 8'8''
25 cm
/ 10''
20 cm
/ 8''
The hole should not accumulate water (in which case the drainage is necessary) and it
should be possible to clean during maintenance.
First, dig the outer hole to create a ledge for
your trampoline frame, which needs to be
25 cm / 10'' deep. This is the exact frame
height, so that the safety pad on top of
the frame will be just above the grass
level. Continue by digging the inner hole.
AKROBAT HINT:
It's a relatively easy task to hand dig the hole for smaller size trampolines, but it
would be best to hire a mini digger to excavate most of the soil and leave you with
the finishing touches.
Note: You will need to save some of the soil for later.
8
INSTALLATION AND USER MANUAL - Primus Flat RECTANGULAR
Dimension B:
Dimension C:
Inner hole
Total depth
110 cm / 3'7''
25 cm / 10''
20 cm
/ 8''
Dig the inner hole according to the
dimensions of your trampoline and with
a bowl-shaped bottom. The inner hole
should be 40 cm / 1'4'' narrower than the
trampoline size. This will leave a 20 cm / 8''
ledge all around on which the trampoline
will sit.
How to measure the hole depth
To properly measure the depth of the hole, use the measuring tape provided in the kit. Stretch
5
the tape over the entire dimension of the trampoline pit. Smaller holes on both sides of the
measuring tape indicate the dimension of your trampoline size. When placing the measuring
tape in the area, it is first necessary to check that the measuring marks indicate the edge
dimension of your trampoline. Once the edge dimension is determined, then you can easily
define the central position of the pit, which indicates, where the pit for your trampoline should
be the deepest (110 cm / 3'7'').
CENTRAL
POSITION
Cover
the
complete
surface
6
the weed protection, then place the
trampoline frame into position. Make
sure the membrane 'hugs' the shape
of the hole and sits right at the bottom
of the hole - keeping wjumping space
under the mat.
with
9