Cypress CP-255D Manual de instrucciones - Página 6

Navegue en línea o descargue pdf Manual de instrucciones para Hardware informático Cypress CP-255D. Cypress CP-255D 12 páginas. Cypress pc/hd to 1080p dvi scaler box
También para Cypress CP-255D: Manual de instrucciones (11 páginas), Manual de instrucciones (16 páginas)

Imprimir página

2. DVI input: Connects this DVI input connector to the DVI output connector of

your DVI source equipment. The DVI input should be digital DVI only and

should not include analog RGB signal.

The use of DVI-I connector is to ensure both DVI-I and DVI-D male connector

of the DVI cable can fit into this input connector. The digital DVI input

resloution can range from 480i~1080p, or VGA~WUXGA.

3. PC-D sub out: The connector for scaled analog RGB output.

Connect this output port to the analog PC RGB input of your monitor, or

connect it to the RGBHV input of your HD display using D-sub to 5 BNC

adaptor cable. (not included in the package)

Note: When input is a HDCP encrypted DVI signal this analog output will be

turned off.

4. DVI output: Scaled digital DVI output. Connect this output to the DVI input or

HDMI input of your Digital display.

Note: When input is a HDCP encrypted DVI signal the DVI output is also HDCP

encrypted. The monitor/display that connected to this output also need to

be HDCP compliant in order to get a nice and clean picture. A non-HDCP

compliant display can only display non-HDCP signal and picture will

become noise when input is a HDCP-encrypted signal.

5. Power jack: Connect to the 5V 2A DC power adaptor.

Remote Control and functions:

1. Power: Press the button once to power on the CP-255D. Press again to enter

standby mode.

2. Input: Press the button repeatedly to toggle through various input sources as

follows.

3. HD input: Press the button to select component input.

4. PC input: Press the button to select PC input.

5. HDMI/DVI input: Press the button to select DVI (or HDMI) input.

6. Output resolution:

Select buttons: Press any one of the button to directly

7. MENU: Press the button to bring up OSD main menu page.

8. Exit: Press the button to exit from a sub menu or main

menu.

9. Up/Down/Left/Right: Press the Up/Down button to move

Component

select output resolution.

For other output resolutions that are not

covered by these buttons please enter

Menu/Output page to select them.

the highlight bar to your desired

parameter during the OSD operation.

Press the Left/Right button to increase/

decrease the setting value of a

selected parameter.

DVI