Asian Electron YK-PIC30122KVA Manual de instrucciones - Página 8
Navegue en línea o descargue pdf Manual de instrucciones para Inversor Asian Electron YK-PIC30122KVA. Asian Electron YK-PIC30122KVA 16 páginas. 19” rack mount pure sine wave inverter with build in battery charger
Imprimir página
2-3 Installation
Where to install：
The unit should be installed in a location that meets the following requirements.
2-3-1 Dry – Do not allow water to drip or splash on the unit.
2-3-2 Cool – Ambient air temperature should be between -20°C and 50°C, the cooler
the better.
2-3-3 Safe – Do not install in a battery compartment or other areas where flammable
fumes may exist, such as fuel storage areas or engine compartments.
2-3-4 Ventilated – Allow at least 3 inch of clearance around the unit for airflow. Ensure
the ventilation openings on the rear and bottom of the unit are not obstructed.
2-3-5 Dust-free – Do not install the unit in a dusty environments where are dust, wood
particles or other filings/shavings.
These dusts can be pulled into the unit when the cooling fan is operating.
2-3-6 Close to batteries – Avoid excessive cable lengths but do not install the unit in the
same compartment as batteries.
Use the recommended wire lengths and sizes (see section 2-6).
Also do not mount the unit where it will be exposed to the gases produced by the
battery. These gases are very corrosive and prolonged exposure that will damage
the unit.
2-4 Quick Hook – Up and Testing
2-4-1 Unpack and inspect the unit, check to see that the switch in the OFF position.
2-4-2 Connect the cables to the unit terminals on the rear panel of unit.
The red terminal is positive (+) and black terminal is negative (-).
Insert the cables into the terminals and tighten relative nut to clamp the wires
securely.
WARNING!
You may observe a spark when you make this connection
since current may flow to charge capacitors in the unit.
Do not make this connection in the presence of flammable
fumes. Explosion or fire may result.
7