ASICO MyLocator KM2012 Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para GPS ASICO MyLocator KM2012. ASICO MyLocator KM2012 8 páginas. Gsm/gps/gprs vehicle/motorcycle motorbikes tracking

Imprimir página

Specification Paramete

Power Supply

Backup Battery

Dimension

Weight

Operating temperature

Humidity

Frequency

GPS Module

GPS Sensitivity

GPS Frequency

C/A Code

Channels

Position Accuracy

Velocity Accuracy

Time Accuracy

Default datum

Reacquisition

Hot start

Warm start

Cold start

Altitude Limit

Velocity Limit

LED

Flash Memory

Interface I/O connector

Problem: Unit will not turn on

Possible Cause:

Wiring was not connected properly

Battery needs charging

Problem: Unit will not respond to SMS

Possible Cause:

GSM antenna was not installed properly

GSM Network is slow

Unit is sleeping

Wrong password in your SMS or wrong SMS format

The SIM in KM-2012 has run out of credit

No SIM card

SIM has PIN code set

Roaming not enabled

Battery is low

+9V ‐+35V / 1.0A

200mAh

64*48*20mm

30g

‐20° to 55° C

5% to 95% Non‐condensing

GSM 850/900/1800/1900Mhz

latest GPS SIRF‐Star III chipset

‐158Db

L1, 1575.42 MHz

1.023 MHz chip rate

20 channel all‐in‐view tracking

5 meters, 2D RMS

0.1 m/s

1 us synchronized to GPS time

WGS‐84

0.1 sec., average

1 sec., average

38 sec., average

42 sec., average

18,000 meters (60,000 feet) max.

515 meters/second (1000 knots) max.

2 LED internal lights to show GPS/GSM working status.

4MB (optional)

3 digital inputs: 1 negative and 2 positive triggering; 1 analog inputs; 1 outputs. 1

Positive, 2GND

Resolution:

Check and make sure wiring connection is in order.

Recharge battery

Resolution:

Make KM-2012 connected to GSM network.

Wait for SMS. Some GSM networks slow down during peak time

or when they have equipment problems.

Cancel sleeping mode

Write correct password or SMS format

Replace or top up the SIM card

Insert working SIM card. Check in phone that the SIM can send

SMS message.

Remove PIN code by inserting SIM in you phone and deleting

the code.

If you are in a different country your SIM account must have

roaming enabled.

Recharge the unit and the GPS will start working.