- ページ 5

GPS ASICO MyLocator KM2012のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ASICO MyLocator KM2012 8 ページ。 Gsm/gps/gprs vehicle/motorcycle motorbikes tracking

5.
Specification Paramete
Power Supply
Backup Battery
Dimension
Weight
Operating temperature
Humidity
Frequency
GPS Module
GPS Sensitivity
GPS Frequency
C/A Code
Channels
Position Accuracy
Velocity Accuracy
Time Accuracy
Default datum
Reacquisition
Hot start
Warm start
Cold start
Altitude Limit
Velocity Limit
LED
Flash Memory
Interface I/O connector
Problem: Unit will not turn on
Possible Cause:
Wiring was not connected properly
Battery needs charging
Problem: Unit will not respond to SMS
Possible Cause:
GSM antenna was not installed properly
GSM Network is slow
Unit is sleeping
Wrong password in your SMS or wrong SMS format
The SIM in KM-2012 has run out of credit
No SIM card
SIM has PIN code set
Roaming not enabled
Battery is low
r
+9V ‐+35V / 1.0A
200mAh
64*48*20mm
30g
‐20° to 55° C
5% to 95% Non‐condensing
GSM 850/900/1800/1900Mhz
latest GPS SIRF‐Star III chipset
‐158Db
L1, 1575.42 MHz
1.023 MHz chip rate
20 channel all‐in‐view tracking
5 meters, 2D RMS
0.1 m/s
1 us synchronized to GPS time
WGS‐84
0.1 sec., average
1 sec., average
38 sec., average
42 sec., average
18,000 meters (60,000 feet) max.
515 meters/second (1000 knots) max.
2 LED internal lights to show GPS/GSM working status.
4MB (optional)
3 digital inputs: 1 negative and 2 positive triggering; 1 analog inputs; 1 outputs. 1
Positive, 2GND
Resolution:
Check and make sure wiring connection is in order.
Recharge battery
Resolution:
Make KM-2012 connected to GSM network.
Wait for SMS. Some GSM networks slow down during peak time
or when they have equipment problems.
Cancel sleeping mode
Write correct password or SMS format
Replace or top up the SIM card
Insert working SIM card. Check in phone that the SIM can send
SMS message.
Remove PIN code by inserting SIM in you phone and deleting
the code.
If you are in a different country your SIM account must have
roaming enabled.
Recharge the unit and the GPS will start working.