EG4 18KPV Manual de instalación
Navegue en línea o descargue pdf Manual de instalación para Adaptador EG4 18KPV. EG4 18KPV 2 páginas. Monitoring adapter | 4g
Imprimir páginaEG4 18KPV Monitoring Adapter | 4G Installation Guide
1. SIM Card Installation
a. Squeeze tabs on the end of the datalogger together and remove the bottom
cover.
b. Pull out the card holder, insert the included SIM card, and then reinsert the
card holder into datalogger.
c. Reattach the bottom cover onto the datalogger and press into place.
Note: The included SIM card comes with 5 years of service. After this time, a
new SIM card will be required to continue 4G monitoring.
2. Datalogger Installation
a. Power down the inverter, following the proper shutdown procedures found in section
6.4 of the user manual which can be downloaded here:
https://eg4electronics.com/downloads/
b. Plug the datalogger into the inverter and affix with the four screws provided (see
diagram below).
3. GPRS/4G Operation
Description of LED light status:
INV LED: Indicates the communication
Module LED: Indicates the status
status between the datalogger and
of the GPRS or 4G module.
inverter.
Net LED: Indicates the communication
status between datalogger and network.
a. Power on the inverter, following the proper startup procedures found in section 6.4 of the user
manual located here:
https://eg4electronics.com/downloads/.
b. When powering on for the first time after installation, the LED of the datalogger will light as follows:
Not Lit
Flashing Green
Solid Green
Reset Button
Remove the bottom cover. One
side is the SIM card holder and
the other side is a button. Press
and hold the button for more
than 3 seconds to reboot the
datalogger.
4. Registration and Adding Device
Note: If an account has been previously created, the datalogger can be added
to the account station using the datalogger SN and PIN (skip registration steps)
a. After connecting the datalogger, create an end-user account by registering
at https://monitor.eg4electronics.com/. To create distributor or installer
accounts, please contact [email protected] for assistance.
b. Or, download the 'EG4 Monitor' app to register for an end-user account.
Available on Google Play or Apple APP store
APP Name: EG4 Monitor
LED Status
Working Status
Not Lit
Not Working
Flashing
Waiting to Work
Solid Green
Working Normal
Scan the QR code which
will take you to the EG4
Electronics downloads
page. Look for the
18KPV-12LV inverter
downloads, then tap on the
appropriate app link.