EG4 18KPV Panduan Instalasi

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Adaptor EG4 18KPV. EG4 18KPV 2 halaman. Monitoring adapter | 4g

Halaman Cetak

EG4 18KPV Monitoring Adapter | 4G Installation Guide

1. SIM Card Installation

a. Squeeze tabs on the end of the datalogger together and remove the bottom

cover.

b. Pull out the card holder, insert the included SIM card, and then reinsert the

card holder into datalogger.

c. Reattach the bottom cover onto the datalogger and press into place.

Note: The included SIM card comes with 5 years of service. After this time, a

new SIM card will be required to continue 4G monitoring.

2. Datalogger Installation

a. Power down the inverter, following the proper shutdown procedures found in section

6.4 of the user manual which can be downloaded here:

https://eg4electronics.com/downloads/

b. Plug the datalogger into the inverter and affix with the four screws provided (see

diagram below).

3. GPRS/4G Operation

Description of LED light status:

INV LED: Indicates the communication

Module LED: Indicates the status

status between the datalogger and

of the GPRS or 4G module.

inverter.

Net LED: Indicates the communication

status between datalogger and network.

a. Power on the inverter, following the proper startup procedures found in section 6.4 of the user

manual located here:

https://eg4electronics.com/downloads/.

b. When powering on for the ﬁrst time after installation, the LED of the datalogger will light as follows:

Not Lit

Flashing Green

Solid Green

Reset Button

Remove the bottom cover. One

side is the SIM card holder and

the other side is a button. Press

and hold the button for more

than 3 seconds to reboot the

datalogger.

4. Registration and Adding Device

Note: If an account has been previously created, the datalogger can be added

to the account station using the datalogger SN and PIN (skip registration steps)

a. After connecting the datalogger, create an end-user account by registering

at https://monitor.eg4electronics.com/. To create distributor or installer

accounts, please contact [email protected] for assistance.

b. Or, download the 'EG4 Monitor' app to register for an end-user account.

Available on Google Play or Apple APP store

APP Name: EG4 Monitor

LED Status

Working Status

Not Lit

Not Working

Flashing

Waiting to Work

Solid Green

Working Normal

Scan the QR code which

will take you to the EG4

Electronics downloads

page. Look for the

18KPV-12LV inverter

downloads, then tap on the

appropriate app link.