BlueSky Mast 350G XL Series Hoja de referencia rápida - Página 5
Navegue en línea o descargue pdf Hoja de referencia rápida para Sistemas de elevación BlueSky Mast 350G XL Series. BlueSky Mast 350G XL Series 10 páginas.
También para BlueSky Mast 350G XL Series: Referencia rápida (10 páginas)
Imprimir página
59
Repeat steps 46 - 50 until you have reached 1/2 the total height of the
mast. Example: a 15M System has 14 poles so stop and deploy second-
ary guying when you have 7 poles remaining.
63
Walk away from the mast and
unwind ALL of the guy rope off of
the handle.
67
When the primary guy ropes go taut or if the mast begins to lean exces-
sively - Stop and Lock the Cam Lock. Now adjust all FOUR PRIMARY
GUY ROPES and make sure the mast is straight and perpendicular.
70
1
If the mast is leaning, Person #1
should go to the guy rope oppo-
site the lean.
Do Not Duplicate, Alter, or Copy without the Express Written Consent
of BlueSky Mast, Inc. Copyright 2016 Allendale LLC All Rights Reserved
350G XL - Lift Series
Quick Reference Sheet - Primary & Secondary Guying
64
Clip the end of the guy rope to the
bottom hole on the guy stake and
lay it on the ground.
71
1
Person #2 should go to the guy rope that is 90 degrees from person #1.
This will allow you to see how far each guy rope needs to be adjusted to
get the mast straight. Rotate to the other guy ropes to finish adjustment.
DEPLOYMENT
60
Lock the cam lock on the Blue
Secondary Guy Ring.
65
Repeat this process until all four
guy ropes have been deployed
using the remaining square holes.
68
Adjust the 4 Primary Guy Ropes
TWO PEOPLE
2
Read Manual Before Use
Refer to detailed instructions in the
350G XL Lift Series Manual at all times
61
Locate the four Secondary Guy
Ropes with the blue tab next to
the guy clip.
66
Continue to raise the mast until the mast begins to lean excessively or
the guy ropes go taut. *Use the Velcro Straps to secure cables and
always monitor the guy ropes.
69
Adjusting the Primary Guy Ropes
Hold the rope in front of the guy handle and slide the handle back to
loosen or forward to tighten.
72
It may take a couple rotations to
get the mast straight and perpen-
dicular.
62
Attach the clip of the first second-
ary guy rope to the round hole on
the secondary guy ring.
73
Confirm that the cable is taut and
the cam lock is locked.